Serpent 950-R i-manual(Shock Assembly)

[T.H.S(김영준)]

1.0 Shock Assembly

Step 1.1 Fasteners: Washer 3x6x0.3mm (N3) C-clip 1.9mm (R1) C-clip 2.3mm (R2) A) Remove plastic flashing for smooth movement of pistons. Tab in upper piston fits in notches in lower piston. B) Front shocks: short shock shaft and body   Rear Shocks:  long shock shaft and body

Step 1.2 A) Lubricate shock shaft with shock oil before inserting in shock body.

Step 1.3 Fasteners: O-Ring 12.1x1.6mm (Y17)

Step 1.4 Fasteners: O-ring 3x1.5mm (Y3) A) Lubricate O-ring with shock oil before sliding onto shock shaft.

Step 1.5 A) Grip shock rod at top of exposed threads with cutting pliers. Be sure not to damage the shock rod. HINT: Pre-thread ball-joint with M3 screw for easy assembly.

Step 1.6 A) Fill the shock body with shock oil,with the piston at the bottom. Bleeding Let the oil settle and allow the air to escape. Slowly move the piston up and down to release any trapped air bubbles. Repeat as necessary until no bubbles appear.

Step 1.7 A) Line up notch. Shock Length Adjustment: Check the length of the shocks in the extended, fully locked position. Front shocks: 67.5mm Rear shocks: 76.5mm IMPORTANT!: Each pair of front and rear shocks must be the same length.

Step 1.8 A) Front Shocks: short shocks and springs   Rear Shocks: long shocks and springs Damping adjustment Pull the shock shaft all the way out, turn slightly to lock it in the shock body. Adjust the shock dampening by rotating the shock shaft CW or CCW to positions 1-4. Each setting can be felt by a slight "click". IMPORTANT! Each pair of front and rear shocks must have the same damping setting.